Advance Training Course on (CCNA)

 

Advance Training Course on (CCNA)

Course duration 3 months
Course Fee: 10,000 Tk
Per weak 2 class
Duration per class 3 hours

Course Outline
CCNA 1 – Introduction to Networks

  • Network basic
  • Network models
  •  OSI Model
  • TCP/IP Model
  • Ethernet Technology
  • IP Addressing
  •  – Subnetting IP Networks
  •  – VLSM
  • Cisco IOS overview
  • Configuring a Network Operating System

CCNA 2 – Routing Essentials

  • Routing Concepts
  • Static Routing
  • Routing Dynamically
  • Routing Information Protocol ( RIP)
  • Enhance Interior Gateway Routing Protocol (EIGRP)
  • Open Shortest Path First (OSPF)
  •  Single Area OSPF
  • Multiarea OSPF
  • Access Control List
  • Dynamic Host Configuration Protocol (DHCP)

 

CCNA 3 – Switching Essentials and Scaling Networks

 

Basic Switching Concepts and Configuration

VLANs

  • Inter-VLAN Routing
  • Spanning Tree Protocol (STP)
  • Rapid Spanning Tree Protocol (RSTP)
  • Per-VLAN Spanning Tree (PVST)
  • LAN Redundancy
  • Hot Standby Router Protocol (HSRP)
  • Virtual Router Redundancy Protocol (VRRP)
  • Gateway Load Balancing Protocol (GLBP)
  • Link Aggregation
  • Wireless Networks

CCNA 4 – Connecting Networks

  • Hierarchical Network Design
  • Connecting to the WAN
  • Network Address Translation (NAT)
  • Point to Point connection
  • Frame Relay
  • Troubleshooting the Network
  • IPv6

Lab 1: Logging into a Router & Introduce with cisco IOS and its features

Lab 2: Basic Router configuration and configuring line console, Telnet, SSH

Lab 3: Configuration back up & restoring the configuration and password recovery

Lab 4: IOS up-gradation by USB, TFTP and IOS up gradation in Common mode

Lab 5: Configuring and verifying Static route and RIP

Lab 6: Configuring and verifying EIGRP

Lab 7: Configuring and verifying OSPF

Lab 8: Basic Switch configurations

Lab 9: Configuring VLANs, Trunk Ports, and Inter-VLAN Routing

Lab 10: Configuring Dynamic Host Configuration Protocol

Lab 11: Configuring HSRP, VRRP, GLBP

Lab 12: Configuring Access List

Lab 13: Configuring Network Address Translation

Lab 14: Configuring Wireless Devices

Lab 15: Configuring Point – to – Point Connection

Lab 16: Configuring Frame relay

 

*** All labs will be done with Cisco Packet Tracer as well as using real Cisco Routers, Switches, and Access points